Triaxial Deformation of the Goldwyer Gas Shale at In Situ Stress Conditions—Part II: Viscoelastic Creep/Relaxation and Frictional Failure

To understand the geomechanical implications of long-term creep (time-dependent deformation) response of gas shale, short-duration creep was recorded from laboratory triaxial tests on ten Goldwyer gas shale samples in the onshore Canning Basin at in situ stress conditions under constant differential axial stress. A simple power-law function captures primary creep behaviour involving elastic compliance constant B and time-dependent factor n. Experimental creep data revealed larger axial creep strain in clay and organic-rich rocks, than those dominated by carbonates. Anisotropic nature of creep was observed depending upon the direction of constant axial stress application (perpendicular or parallel to the bedding plane). Upon the application of linear viscoelastic theory on laboratory creep fitting coefficients, differential horizontal stress accumulation over a geological time scale was estimated from the viscoelastic stress relaxation concept. Further, this model was used to derive lithology-dependent least principal stress (S _hmin) magnitude at depth for two vertical wells intersecting the Goldwyer gas shale formations. This newly proposed S _hmin model was found to have a profound influence on designing hydraulic fracture simulation. Further, pore size distribution and specific surface area value S_N2 were derived from low-pressure gas adsorption experiments. These physical properties along with weak mineral components were linked with creep constitutive parameters to understand the physical mechanisms of creep. A strong correlation was noted between S_N2 and creep parameters n and B. Finally, an attempt was made to investigate how gas shale composition and failure frictional properties can influence shear fracturing.